Lubrication agent: moistening and lubricating pipes
Used to replace cement mortar for lubricating pipes before concrete pumping. At normal temperature, it can quickly dissolve in water to form a lubricating film composed of countless micro-anions, thereby making The surface of the inner tube wall of the pump is fully lubricated.
The principle of using lubricant to prevent pipe clogging and extend the life of the pump pipe is also very simple: because the dry pump pipe will absorb the mortar and moisture in the pumped concrete, especially in high temperature seasons, causing the pump to The rapid decrease in the slump of the pumped concrete will eventually lead to pipe blockage due to an imbalance in the water-cement ratio of the pumped concrete. Through lubricant, the pump pipe can be moistened and lubricated in advance to reduce the slump loss of pumped concrete.
Are you still using the old method to lubricate your pump?
Over the past few decades, the ready-mixed concrete industry has been using the traditional mortar pump lubrication method, which requires pump mortar to be transported to the construction site via mixer trucks. Every time the pump truck arrives at a construction site or the time between two pumping operations is slightly longer, the mixing station must send the mixer truck to the construction site to transport mortar. Generally, a pump truck needs to change 2-3 construction sites a day, and a mixer truck that transports mortar needs 2-3 trips. This not only results in a decrease in the efficiency of the mixer truck, but also consumes a certain amount of mortar raw materials, working hours, manpower, vehicle losses, fuel and other resources, which is extremely detrimental to cost savings, energy conservation and emission reduction. Moreover, when the mortar is not evenly distributed or relatively concentrated in the building, it is easy to cause cracks in the building plate structure and “hollowing out” of the load-bearing components due to the lack of coarse aggregate.
It can be solved with just one pack of moisturizer, so why bother?
Anhui Yulong pipe lubricant product,
It not only overcomes all the disadvantages of the traditional pump lubricating method, is suitable for various grades of concrete, and reduces the friction coefficient of the inner wall of the pump pipe during pumping and Pipe resistance. It not only avoids the blockage accidents of concrete pumps and on-site mortar pumps, reduces transportation vehicles, improves equipment utilization and pumping capacity, but also extends the service life of pump pipes. Traditional pump mortar and ordinary lubricants Totally incomparable.
Every time you use Anhui Yulong pipe lubricant, you can save about 230 yuan in pump mortar and transportation vehicle costs. Calculated based on the annual output of 200,000 cubic meters of concrete and 100,000 cubic meters of ready-mixed mortar, if the pump is operated 2,600 times per year, approximately 600,000 yuan can be saved per year (this does not include the money saved by extending the life of the pump pipes).
This truly saves you time, effort and worry.
Still not able to use lubricant? look here!
Before pumping, first put a certain amount of water into the hopper of the pump truck as required (generally enough to cover more than 1/2 of the eye plate), and then slowly and evenly add lubricant to the water product, and stir continuously (you can open the swing valve of the pump truck, so that the swing valve of the pump truck swings back and forth in the bucket more than 3 times) until the product is completely dissolved. Then turn on the positive pump, pump out the solution in the pipe, and at the same time dump the concrete into the hopper and complete the pumping operation.
</p
微信扫一扫打赏
Chinese