1. Product introduction
High-efficiency concrete release agent is a water-based emulsion specially processed from a variety of film-forming materials and special additives. This product is easy to strip, does not corrode the steel plate, and has a good protective effect on the mold. The surface of the concrete component after stripping is smooth, beautiful in appearance, and has small bubbles. It is especially suitable for the stripping of formwork that has higher requirements on the concrete surface. The use ambient temperature It should be above zero degrees Celsius.
2. Technical indicators
Appearance: white thick emulsion PH: 7-8 Specific gravity: 0.98 Specific gravity: 098
Fineness: 1-2um Film forming temperature: not less than 0 degrees Emulsion stability: no delamination and segregation for half a year
3. How to use
First remove the adherents and impurities on the template surface, and then spray or brush the release agent evenly on the mold surface. Coating amount: 200 grams/square meter. Rainwater should be prevented after coating. Concrete can be poured normally after the coating film dries. If the mold is made of wooden plywood, the release agent should be carefully applied twice and allowed to dry when used for the first time. This product can be used by adding water according to the situation.
IV. Packaging and Storage
1. This product is packed in plastic barrels, 25kg per barrel. Shelf life is one year.
2. The product will stratify during the storage period. It can be used after a little stirring and it will not affect the release effect.
</p
微信扫一扫打赏
Chinese